> -----Original Message-----
> From: Andy Bierman [mailto:abierman@cisco.com]
> Sent: Wednesday, April 16, 2003 3:03 PM
> To: John Strassner
> Cc: Allen, Keith; xmlconf@ops.ietf.org
> Subject: RE: charter proposal - rev C
>
> At 02:53 PM 4/16/2003 -0600, John Strassner wrote:
>
> >OK, I'll see the bet and raise the ante. Could you explain succinctly why
> we need a new protocol at all? Why instead aren't we defining WSDL
> messages for different functions, and then using SOAP bindings and UDDI to
> solve the problem?
>
> As far as I can tell, there isn't widespread interest in
> going that direction by operators or network equipment vendors.
>
>
Let's let the customers make some decisions here.
Brendan
> >regards,
> >John
>
> Andy
>
>
> >
> >John Strassner
> >Chief Strategy Officer
> >Intelliden Corporation
> >90 South Cascade Avenue
> >Colorado Springs, CO 80903 USA
> >phone: +1.719.785.0648
> > FAX: +1.719.785.0644
> >email: john.strassner@intelliden.com
> >
> >
> >-----Original Message-----
> >From: Andy Bierman [<mailto:abierman@cisco.com>mailto:abierman@cisco.com]
> >Sent: Wednesday, April 16, 2003 2:46 PM
> >To: Allen, Keith
> >Cc: xmlconf@ops.ietf.org
> >Subject: RE: charter proposal - rev C
> >
> >At 03:09 PM 4/16/2003 -0500, Allen, Keith wrote:
> >>All,
> >>
> >>It seems to me, based on my admittedly limited knowledge in the area,
> >>that a main output of the working group should be a WSDL description of
> >>the network configuration service. Is this something that needs to be
> >>part of the charter or is this something the WG would decide once it is
> >>underway?
> >
> >This could be discussed by the WG. So far, I have only heard interest in
> WSDL from one person. If there is enough WG interest in this extra
> deliverable, then it could be done by the WG at some point. It could also
> be done separately, outside the WG, as an Informational RFC.
> >
> >>Keith Allen
> >>SBC Technology Resources
> >>9505 Arboretum Blvd.
> >>Austin, TX 78759
> >>(512) 372-5741
> >>kallen@tri.sbc.com
> >>
> >
> >Andy
> >
> >
> >
> >>--
> >>to unsubscribe send a message to xmlconf-request@ops.ietf.org with the
> >>word 'unsubscribe' in a single line as the message text body.
> >>archive:
> <<http://ops.ietf.org/lists/xmlconf/>http://ops.ietf.org/lists/xmlconf/>
> >
> >--
> >to unsubscribe send a message to xmlconf-request@ops.ietf.org with the
> word 'unsubscribe' in a single line as the message text body.
> >
> >archive:
> <<http://ops.ietf.org/lists/xmlconf/>http://ops.ietf.org/lists/xmlconf/>
>
>
> --
> to unsubscribe send a message to xmlconf-request@ops.ietf.org with
> the word 'unsubscribe' in a single line as the message text body.
> archive: <http://ops.ietf.org/lists/xmlconf/>