Re: Non-member submission from [Roland.Meyer@nokia.com]

[Jon Saperia <saperia@jdscons.com>]

Thanks very much. I looked at the Inet CIDR Route Table since if it were
every widely implemented correctly, it would be very helpful.  I think
it is just what I was looking for. I assume the following are true
statements:

        1. When done this table will replace the current CIDR Route
        Table since it is designed to hold both v4 and v6 addresses. 

        2. The general index structure is pretty helpful and can be used
        as a model for tables in the future that need network layer
        addresses as their indicies.

/jon



> Hi Roland,
> 
> "Wijnen, Bert (Bert)" wrote:
> > 
> > Forwarding a non-meber posting
> > 
> > >
> > > Hi,
> > >
> > > Perhaps somebody can answer the following questions:
> > >
> > > What is the current state of the IPv6MIB design?
> 
> All I can say here is that these MIBs are being modelled on the
> lines of the existing IPv4 MIBs. Not sure about how much work 
> is still to be done, guess that part could be better responded
> to by the authors..
> 
> > > Where can one find (preliminary) results of the design work?
> 
> You can find the draft versions of these MIBs at 
> http://www.aciri.org/fenner/mibs/v6/
> 
> HTH.
> 
> Rajiv.
> 
> 
> > >
> > > Thanks,
> > > Roland
> > >
> 

Thanks,
/jon
--

Jon Saperia		     saperia@jdscons.com
			     Phone: 617-744-1079
			     Fax:   617-249-0874
			     http://www.jdscons.com/